SP Tools

This 39 mm was released to help the technician remove and install 12 point axle nuts on 2007 and newer Tundra and Sequoia trucks / SUV’s. 

This unique tool allows the technician to hold the water pump pulley securely while removing the viscous fan clutch on BMW V-8 and Sprinter Vans. 

•Compact slide hammer design is necessary on V-8 applications •On the 8 cylinder V-8 4.4 liter turbo (N63) the tool will pay for itself on the first job. •Quicker than using the factory tool that needs to be worked down and around the injector. •Make 

This tool has been upgraded with spring loaded "silver" legs that allow the technician to set leg position prior to installing on the harmonic damper pulley to aid in the removal of the harmonic damper pulleys found on many Chrysler, and G.M. engines. 

This unique tool is designed to aid the technician in removal of the fan clutch. It’s pin design mates to the holes in the drive pulley of the fan clutch so that the technician can loosed the fan clutch nut. Holding this pulley correctly is required in  

This socket and hex tool were developed to aid the technician in servicing the GM Duramax diesel trucks. SEE ALSO #69250 GM DURAMAX FLYWHEEL LOCK. 

This unique tool was designed to hold the flywheel stationary when removing or replacing the crankshaft bolt. SEE ALSO #69200 DURAMAX CRANKSHAFT AND FLYWHEEL KIT 

This unique tool was designed to remove and install lower ball joints on the car versus removing the steering knuckle and using a press. 

HONDA / ACURA BUSHING X-TRACTOR™. “REMOVAL AND INSTALLAITON TOOL” 

This unique tool was designed to reach down through the engine compartment in areas not easily accessed with conventional tools. This tool has a specific “clock” angle of the 6 point 19 mm end with carefully calculated handle geometry enabling access to 

This unique tool was designed to allow the technician to support the engine. Works on: 2006 and later IS250 2WD 2006 and later IS350 2WD 2006 GS 300 2WD 2007 and later GS350 2WD 

This specialty designed patent pending dual ended tool has small magnets that are designed to aid in the removal of hard to reach washers that are around most types of studs. 

Manual Bushing R&R Tool allows the technician to service a wide range of bushings without removing components from the vehicle. 

“Used for bushings, wheel bearings* and ball joints” This Mobile Hydraulic Press Tool allows the technician to service a wide range of bushings, wheel bearings* and ball joints without removing components from the vehicle. 

Forged • 6 Point • Super Strong This unique tool has been designed to R&R "can" type shielded oxygen sensors and air fuel sensors currently found on later models vehicles. 

This wrench is designed with small diameter grooved pins to allow access to small hole cam gears. 

This unique tool allows the technician to access the tensioner from the top side of the engine. This saves the technician tremendous time as compared to the current method of accessing from the bottom of the engine. 

Updates #91400A or similar kits that have a 5/8” bar. The update kit includes: 2 hex sliders, 3 detent clevis pins, short arm and hex bar. 

This socket has been designed to remove the left and right fuel pump retaining nuts on all late model Volvos. 

This unique tool was designed to compress the hydraulic timing belt tensioner when servicing the water pump.