SP Tools

This wrench has been designed for use with most all oxygen sensors no matter what size electrical connectors they have. 

12 & 6 POINT 2-1/8" offset OXYGEN SENSOR WRENCH works with many GM products found in Corvettes, Camaros and Firebird/Trans Am. 

"For Use On Most Constant Tension Type Hose Clamp"s 

Four pin #63600 for AUDI & VW ENGINES with “Pressed on”water pump pulleys. 

Serpentine, Timing & V-Belt installation assist 

For use on Aluminum & Steel Heads 

On 1988 and later, 5 & 7 series BMW's, the lower "A" arm bushing nuts are inaccessible with standard wrenches. 

Designed to be used on 5, X5, and 7 series vehicles that have 16 mm or 18 mm crush nuts on the rear toe cam bolt adjusters. 

•Specially designed T60 torx tip gives the technician greater control when compressing the tensioner. 

This tool has been developed to easily remove CIS fuel injectors on many in-line engines including all gasoline water-cooled Volkswagen, Porsche 924, and Audi automobiles. 

This unique tool has been designed to measure the end play movement of the VW crankshaft without the use of a dial indicator. 

The #62050 fan clutch wrench five piece kit with rack and quick reference guide gives the professional technician the ability to service all fan clutches that have "bolt on" and "pressed on" pulleys on the water pump. Works with Chrysler, GM, Ford, Land 

This specialty wrench fits on Fiat & Yugo oil drain plugs with a 12mm hex. 

These unique tools have been developed for use in disconnecting the fuel and air conditioning line couplers found on most late model automobiles. 

These unique tools have been developed for use in disconnecting the fuel and air conditioning line couplers found on most late model automobiles. 

These unique tools have been developed for use in disconnecting the fuel and air conditioning line couplers found on most late model automobiles. 

Part Number(s) #66110 66120 66130. These unique tool sets allows the technician to easily lift and maneuver cylinder heads when service is needed. 

This specialty designed patent pending dual ended tool has small magnets that are designed to aid in the removal of hard to reach washers that are around most types of studs. 

These pliers have been developed to remove the valve stem seals which are used on most overhead camshaft engines. 

UNIVERSAL OHC VALVE SPRING COMPRESSOR Updates #91400 or similar kits that have a 5/8” bar