SP Tools

This unique tool has been designed to R&R "can" type shielded oxygen sensors currently found on later models of Toyota and Lexus vehicles (excluding 2004 and later four cylinder engines) also 2007 and later Mazda's that have a heat 

This 39 mm was released to help the technician remove and install 12 point axle nuts on 2007 and newer Tundra and Sequoia trucks / SUV’s. 

This unique tool was designed to allow the technician to support the engine. Works on: 2006 and later IS250 2WD 2006 and later IS350 2WD 2006 GS 300 2WD 2007 and later GS350 2WD 

Manual Bushing R&R Tool allows the technician to service a wide range of bushings without removing components from the vehicle. 

“Used for bushings, wheel bearings* and ball joints” This Mobile Hydraulic Press Tool allows the technician to service a wide range of bushings, wheel bearings* and ball joints without removing components from the vehicle. 

This specialty wrench is for use on most 1970 and later model AMC, Ford, General Motors, Isuzu, Jeep, Nissan, Opel and Toyota automobiles with rear mounted Monroe replacement shock absorbers. 

Forged • 6 Point • Super Strong This unique tool has been designed to R&R "can" type shielded oxygen sensors and air fuel sensors currently found on later models vehicles. 

This unique tool allows the technician to access the tensioner from the top side of the engine. This saves the technician tremendous time as compared to the current method of accessing from the bottom of the engine. 

TOYOTA & LEXUS V6 CAM SEAL REMOVER & INSTALLATION SET 

This unique tool combines a 30 mm, 12 point special depth impact 1/2 inch drive socket with a lock nut release tool to unlock the 30 mm axle nut on both front and rear wheel drive vehicles. The lock nut release tool has a patent pendi 

Developed to aid in the removal and installation of the crank bolt on Lexus and Toyota engines. 

T100, Tacoma, Tundra Pickup & 4 Runner SUV 

The professional technician has no means to effectively compress the hydraulically activated belt tensioner without spending additional time removing engine components. This is the tool for you. 

Part Number #65500 has been upgraded to Part Number #65510. 

This unique tool has been designed to allow for easy valve adjustment on most Toyota’s overhead camshaft engines using spacer shims for valve adjustment. 

This tool is designed to install the cam seals in 4 & 6 cylinder engines for Mazda, Nissan & Toyota/Lexus engines. For Toyota•Lexus cam seal installer and remover see 65510. 

With this latest evolution to our Universal Valve Spring Tool we have added the ability to actuate the compression tube even in tight confined locations like under the cowl where the lever cannot be moved or may not even fit. 

Updates #91400A or similar kits that have a 5/8” bar. The update kit includes: 2 hex sliders, 3 detent clevis pins, short arm and hex bar.