SP Tools

This wrench has been designed for use with most all oxygen sensors no matter what size electrical connectors they have. 

12 & 6 POINT 2-1/8" offset OXYGEN SENSOR WRENCH works with many GM products found in Corvettes, Camaros and Firebird/Trans Am. 

This special 24 mm flare nut type wrench will slide back into the recessed area of the cylinder head where the fuel line retainer screws into the head. 

"For Use On Most Constant Tension Type Hose Clamp"s 

Serpentine, Timing & V-Belt installation assist 

For use on Aluminum & Steel Heads 

Part Number #67400. Bendix type brake valve holder. This specially designed holding tool was manufactured to hold two treadle valves so that the attaching air pressure fittings can be exchanged from the old valve to the new valve. 

This unique tool allows the technician to hold the water pump pulley securely while removing the viscous fan clutch on BMW V-8 and Sprinter Vans. 

This unique tool has been developed to remove and install the water pump on Cadillac Northstar 4.6 liter V-8 engines from 1993 and later also Oldsmobile Aurora 4.0 liter V-8 engines 1995 and later. 

This tool easily removes heater hoses with 3/4" or 5/8" quick disconnect couplings. 

This tool has been upgraded with spring loaded "silver" legs that allow the technician to set leg position prior to installing on the harmonic damper pulley to aid in the removal of the harmonic damper pulleys found on many Chrysler, and G.M. engines. 

This specialty Puller/Installer is designed to facilitate easy removal and installation of the crankshaft pulley on all 1981-1994 2.2 liter engines and 1986-1994 2.5 liter engines. In operation, the universal hole pattern allows for adaptation to early fo 

This unique tool has been developed to aid in the removal and installation of the crank bolt on most Chrysler engines. 

Five pin domestic gas engines for Chrysler & GM LATE MODEL GAS ENGINES with “Pressed on” water pump pulleys. 

These specialty offset wrenches have been designed to remove and install the 10mm and 13mm injection pump mounting bolts and idle lock nuts found on Cummins B series 5.9L diesel engines. 

The area surrounding the injection pumps on later model 4 valve ISC 8.3 liter and ISB 5.9 liter engines is very difficult to access when removing the fuel supply lines. 

This special 3/8" drive barring tool is used when making valve adjustments or pump settings and is made with a two piece sleeve to change depth of insertion. 

This specialty wrench was designed for Dodge and Mitsubishi 4x4 trucks with the KM145 transmission. This includes the 1984 and later Dodge Ram D-50 pick-up, Dodge Raider, Mitsubishi Montero, and Mitsubishi MAX pick-up. 

This tool was designed to reach down through the engine compartment in areas that are not easily accessible with standard tools or “universal” belt tensioner tools. 

This 3 pin fan clutch wrench has been developed to work on the 2009 and later 5.7 liter Hemi Truck engine. With it’s long reinforced pins it firmly engages the hard to reach holes on the conical shaped water pump pulley. Used with 95210, removing the fa