HONDA / ACURA INTEGRA TRAILING ARM BUSHING X-TRACTOR™ UPDATE KIT For 65100 will do 1990-1993 INTEGRA 

This unique tool was designed to remove and install lower ball joints on the car versus removing the steering knuckle and using a press. 

HONDA / ACURA BUSHING X-TRACTOR™. “REMOVAL AND INSTALLAITON TOOL” 

Part Number #65100 has been upgraded to #65130 

This tool was developed to aid in the alignment of the clutch disc to the flywheel and cover. 

This unique tool was designed to aid in the removal of the front lower control arm compliance bushings both 65 mm and 74 mm sizes found on many Honda and Acura vehicles. 

This unique tool was designed to reach down through the engine compartment in areas not easily accessed with conventional tools. This tool has a specific “clock” angle of the 6 point 19 mm end with carefully calculated handle geometry enabling access to 

This unique 50mm tool has been developed to aid in the removal and installation of the crank bolt on most Honda and Acura engines. 

This tool allows the technician to accurately remove and install the shift linkage pin on vehicles using shift rod linkage. 

This unique tool has been developed to aid in the installation of balance and camshaft seals for most Honda and Acura engines. 

This tool allows the technician to accurately remove and install the shift linkage pin on vehicles using shift rod linkage. 

Manual Bushing R&R Tool allows the technician to service a wide range of bushings without removing components from the vehicle. 

“Used for bushings, wheel bearings* and ball joints” This Mobile Hydraulic Press Tool allows the technician to service a wide range of bushings, wheel bearings* and ball joints without removing components from the vehicle. 

This wrench is designed with small diameter grooved pins to allow access to small hole cam gears. 

With this latest evolution to our Universal Valve Spring Tool we have added the ability to actuate the compression tube even in tight confined locations like under the cowl where the lever cannot be moved or may not even fit. 

This Universal Valve Adjustment Tool has been designed for a wide variety of cars with 10mm jam nut valve adjustment screws. 

This Universal Valve Adjustment Tool has been designed for a wide variety of cars with 12mm jam nut valve adjustment screws. 

Updates #91400A or similar kits that have a 5/8” bar. The update kit includes: 2 hex sliders, 3 detent clevis pins, short arm and hex bar.